From time to time, I get the red check system light flashing. The message will usually be “low amp” but sometimes it will say something like “check system/c”. I have unplugged from the salt cell and then plugged back in and often the red light will stop flashing. Is this a salt cell issue, would cleaning it make more make a difference. Please offer any suggestion, the cell is original from pool installation 6 years ago. Thanks.
“Check System” Light
- by Nigel
- One reply
1 thought on ““Check System” Light”
Mo this could be a dirty or bad cell. When you get the lo amps msg the systems conductivity is low. This could also be caused by a dirty connection or a bad cell cable, bad tri-sensor, bad power board and or low salt level in pool. If all else fails contact our Service Support Desk to book a diagnostic of your salt system.