Install reading Celsius need to read in Fahrenheit How do I change it
New control board P.N. 4PB00931D
- by Nigel
- 5 replies
Your trusted partner in home improvement and backyard leisure.
Install reading Celsius need to read in Fahrenheit How do I change it
5 thoughts on “New control board P.N. 4PB00931D”
Steve what make and model spa do you have and what year was it built? This info can be found on the i.d sticker near the Sentry Control Box.
My tube is a 2001 Palermo I have corrected the problem with reading Celsius by removing the jumper on 7-8 pins. Now to find out that when the tech installed it They put one of the power wires on the neutral spade single phase the hole system I need to know power confirmation on the board to get it wired properly I hope there is no damage to the board. It cost me $800.00 dollars
Steve depending on the revision of board you have installed you can trace your power in/power out connections on the diagram that is affixed to the rear of the Sentry Control box cover. If all else fails contact your local Sundance Support Desk to book a diagnostic and repair of your Sundance Palermo spa.
installed new control board Part # 4PB00931D in a 2005 Sundance Palermo spa. 2 pumps. Keeps blinkimg can’t get it to program. Any sugestions?
Hi Bob. I don’t recognize that part number as a Sundance Bahia spa part number. It’s very likely that the board you have is just not compatible if it is not a Sundance part. I’ve attached a purchase link for the latest revision circuit board for a 2005 Sundance Bahia for your convenience. If your spa is a 2005 Bahia this board will work. If you purchase it from this link tonite it would ship tomorrow. https://support.aqua-tech.ca/store/index.php/sundance-parts/electronics/sundance-spas-pwa-motherboard-2-pump-logic-part-number-6600-726.html